Hall sensor testing
1)The fist step is determine if the HALL sensor works with 5v or 12v.
WARNING !! a mistake in this point can damege the sensor !!
2) Other distinctive variation of differents hall sensor is their output type.:
To test a sensor you will need a magnet. Can connect of the following way or use a wire puncturer and connect from sensor out to TPS1 input.
3)The HALL effect is based on the magnetic field receipt.
So you must close and remove the magnet while look the answer on screen.
The normal is that see some of the following changes: 0v-12v, 0v-5v, 0v-Open.
4) Note that the magnet have 2 poles in the same piece ( north and south), and some sensors detect this. So if yo see no output change try
invert the magnet, search differents angles and differents places of sensor.
