SCHlabs - Complete Engine protector for cars, 2 Temperatures, Oil, Voltage w/Alarm and shutdown

This device is essential to save the engine live.
The overtemperature is the most frequent cause of car engines dead.
The red Light or original indicator generally only advice after damage.

Knowing the importance of temperature control, this device measure 2 temperatures simultaneously.
Coolant temperature and in leak case take the control another sensor into the head cup will take action.
Also monitor the Oil pressure and charge voltage to alarm to the driver and save the engine.

So easy to install as connect 12v, ground, and probe.
Economic, small and efficient.

Configuration

Setup

Login
You in into setup mode pressing the middle button while 3 seconds.
Se ingresa en el modo configuración presionando el botón central. The screen will show: SET-XX where XX is the version of product.
Use upper an lower buttons to choose the apropriated option and press the central button. Change the values with the Upper and Lower buttons. At end use the middle button again.

Cr1

Critical Temperature

Choose the temperature taking care that the advice start whe this number is override. An the shutdown is 6 degrees more than this number

Cr2

Temperature

Choose the temperature taking care that the advice start whe this number is override. An the shutdown is 6 degrees more than this number

VMI

Voltage Mínimum

Choose the thereshold voltage under that trigger the alarm

VMA

Voltage Máximum

Choose the thereshold voltage over that trigger the alarm

FAN

Electro

0=with the fan off there are 12v
1=with the fan off there are 0V in the wire

C-F

Grados

0=Centigrades degrees
1=Fahrenheit degrees

BrI

Brightness

Adjusts the screen brightness

DLY

Delay

Isthe time in seconds between the shutdown condition and the shutdown

DRV

Driver

1= Forces the driver to wait for the engine to cool down before being able to continue driving. (It is recommended to activate a delay that allows the driver to park to the side)

GPS

(only in models with this signal) Select wich temperature will be send to the GPS tracking system

EnD

END

Store the changes and end the setup menu.