Status : Selling To buy this product please visit our store, following the link
Complete Engine protector for cars, 2 Temperatures, Oil, Voltage w/Alarm and shutdown
This device is essential to save the engine live.
The overtemperature is the most frequent cause of car engines dead.
The red Light or original indicator generally only advice after damage.
Knowing the importance of temperature control, this device measure 2 temperatures simultaneously.
Coolant temperature and in leak case take the control another sensor into the head cup will take action.
Also monitor the Oil pressure and charge voltage to alarm to the driver and save the engine.
So easy to install as connect 12v, ground, and probe.
Economic, small and efficient.
How work
The TAU2-plus measure permanently and simultaneously 5 parameters: 2 temperatures, the charging voltage, radiator fan, presence of Oil pressure from original bulb (on/off).
For display reason it only one parameter at a time. With the up and down button you can change the displayed data in the following order.
T 1
Cylinder cover temperature
C° o F°
T 2
Coolant temperature
C° o F°
OIL
Oil pressure existence
0=without, 1=With pressure
VOL
Charging voltage
Volt
The engine temperatures is shown in a range from 0°c ~ 140°c (32°f~284°f).
When at least one temp is greater to the critical set by user, or voltage is out of operating range, or Oil pressure fail ( for more than 15 seconds) the alarm will start. The screen will show the reason (T1, T2, Oil, Volt), the digits will blink and the noise start ( one beep by each additional degree). On this way the alarm is more annoying when more greater is the overheat.
Pressing the middle button the sound will be muted. The mute will remain until the parameters go to normal.
When the temp exceed on 6 degree the critical temperature, the voltage or oil fail the RED led will turn on and send the shutdown signal. The shutdown signal is immediate from factory but you can configure a delay up to 64 seconds. If mode driver is disabled, the middle button allow continue the travel.
If when you start, the TAU detect any fail condition, the alarm and shutdown will not activated until the situation go to normal.
When the radiator fan turn on, the blue LED will turn on, but no alarm will be generated.
