This product is a revolution for CNG world.
Is a fuel switch for vehicles working at CNG.
The strong feature of this product is measure the pressure of tube in Bars.
With at least 10 more extra function make the best CNG product, the customers recommend one to another mouth to mouth.
Despite having so many functions, it is EASY to use, which is very important.
Built entirely of solid state, which means it has no moving parts or wear. That makes it easier to provide a 2 year warranty.
There are 3 variants with differents functions:
-Green digit switch ( the most economic)
-Red digit switch
-Blue digit switch ( more functions )
How do I calibrate the RPM to which you must go from gasoline to gas?
While in NAFTA mode, accelerate until the engine turns at about 2000 RPM or so press the NAFTA button, while holding it down press GAS.
The RPM message will appear for about 2 seconds, keep the engine at 2000 turns that time
How to change carburetor injection or vice versa?
1) Turn off the engine
2) Press the 3 buttons simultaneously
3) Turn the ignition switch
4) Wait 1 second and release the buttons
5) A message C-Y will appear
6) Press to
NAFTA = INJECTION
GAS = CARBURETTOR
OFF = Does not change the current
How do I set the change to smart naphtha (my car is a carburetor)?
1) Turn off the engine
2) Press the 3 buttons simultaneously
3) Turn the ignition switch
4) Wait 1 second and release the buttons
5) A message C-Y will appear
6) Press OFF 2 times
7) A G-N message will appear
8) Press to
NAFTA = Activda
GAS = Disabled
OFF = Does not change the current
How do I measure in percentage?
1) Turn off the engine
2) Press the 3 buttons simultaneously
3) Turn the ignition switch
4) Wait 1 second and release the buttons
5) A message C-Y will appear
6) If the vehicle is injection press OFF 1 time
If the vehicle is carburetor press OFF 2 times
7) A B-P message will appear
8) Press to
NAFTA = Percentage
GAS = BARes
OFF = Does not change the current
How do I make the gas change only to naphtha?
1) Turn off the engine
2) Press the 3 buttons simultaneously
3) Turn the ignition switch
4) Wait 1 second and release the buttons
5) A message C-Y will appear
6) If the vehicle is injection press OFF 2 times
If the vehicle is a carburetor press OFF 3 times
7) A LOW message will appear
8) Press to
NAFTA = Change activated
GAS = Change Off
OFF = Does not change the current
How do I change it in DEACC (my vehicle is injection)?
1) Turn off the engine
2) Press the 3 buttons simultaneously
3) Turn the ignition switch
4) Wait 1 second and release the buttons
5) A message C-Y will appear
6) Press OFF 3 times
7) A DES message will appear
8) Press to
NAFTA = Deceleration activated
GAS = Normal
OFF = Does not change the current
How do I adjust the brightness of the digits?
1) Turn off the engine
2) Press the 3 buttons simultaneously
3) Turn the ignition switch
4) Wait 1 second and release the buttons
5) A message C-Y will appear
6) If the vehicle is injection press OFF 4 times
If the vehicle is carburetor press OFF 4 times
7) A Bxx message will appear, where xx is the current brightness (0 max to 15 min)
8) Press to
NAFTA = Increases brightness
GAS = Low brightness
OFF = Does not change the current
I did not understand, how do I configure my selector?