Logo
Switch to desktop viewElectroincs in action
You are in: Products > Automobile > HMP1 > 120.09
Important: SCHlabs has permanently moved its operations from Argentina to Spain. Our new website is: https://www.ludfed.com

Multi car sensor and actuator tester


Code : HMP1




Poduct comment::«Everything was fine, I recommend it to everyone! Thanks! ++++++++++(ebay kovacsmis)»

Multi car sensor and actuator tester


The HMP1 is the most complete tool for mechanics testing, reading and/or emulating almost all car sensors.
It is so complete that it becomes the essential tool for servicing internal combustion vehicles.

Among its functions, we can highlight its ability to read and generate CKP & double CMP pulses simultaneously and the complete test of motorized throttle bodies and many more functions.

There are 3 types of possible actions for each sensor.
[T] Test. It means that the HMP1 can check the operation with the sensor/actuator outside the car (or disconnected)
[R] Reading. It means that you can read the operation without disconnecting it from the car and read/monitor its operation that way.
[E] Emulate. It means that the HMP will act as if it were the sensor so that the injection “believes” that the sensor is in place and working.

Sensor/Actuator
Possible actions
Electronic Throttle
Test, Read
Pedal
Test, Read
Analog Voltage Map/Maf/TPS
Read, Emulate and test when powered with 5v
Frequency MAP
Pulse Reader [R] / Pulse Generator [E]
Lambda Narrow
Read, Emulate
ECT (NTC type temperature sensor)
Test
Inductive injectors
Test, Read
IAC / step by step
Test
EGR / canister /Turbo
Test, Read
HALL sensors
Reading, Test on sensors powered with 5v
CKP & CMP
Simultaneous read, emulation
Ignition Modules
Read, Test
ABS
Read, Emulation
Battery/Alternator
Read


PWM Generator

Many times it is necessary to generate pulses to make work a car component with 12v pulses and variable duty.
This function can test or run PWM actuators such as Turbo Actuators, EGRs, Canister Valves, Solenoids, Common Rail Relief Valves and other PWM type actuators up to a maximum current of 4.0A.
Connect as follows:

Usage:
1) Disconnect the IAC valve from the rest of the car.
2) Connect the outputs of MOTOR 1 and MOTOR 2 to the actuator.

image

3) Connect the 12v to HMP1 and wait for the menu to appear on the screen.
4) Press the "+" and "-" buttons until you see writing "PWM".


5) Press OK and the following information will appear on the screen:
image
PWM
You are testing an EGR, turbo, Canister, etc using 12v pulses
+20
A 20% duty is being applied
0.40
It is the current that is consuming the actuator

6) When finished Press OK and the maximum current consumed by the valve will appear on the screen.